The span from one end to the other of this cabinet is pretty long. As a result the center section supporting all of the drawers was sagging about 3/8 of an inch. To stiffen it up a bit, I’ve installed some studs attached to the bottom rails to support the bottom. Hopefully that will fix things up. If not I’ll have to add a small center leg to support the bottom. You would never notice it unless you were on your hands and knees, but I still hope to avoid adding it.

On a positive note, two new brushes were able to revive the planer. And while I was in maintenance mode, I finally replaced the busted plug on the table saw…