Spent Mother’s Day in the shop. None of these pieces are for her though (sorry Mom). Most of the day was spent between assembly, sanding and fit work. The tall cherry piece in the photo below was the dry fit of the back part of the new cabinet I’m working on. The four corners of the piece feature through dovetails. The back is a panel about 1/16th of an inch thick. The wood for the panel is from the same pieces used to make the sides of the cabinet. My cherry stock was pretty thick, so I resawed it to get the backs and the sides out of the same piece of lumber. The walnut piece below is in the middle of being fit for the 4 drawers in the center section of the piece. Little more fit work on the drawers and doors next week and then this one will be ready for finishing…